Anritsu ML2430A Manual do Utilizador descarregar pdf (Página 121)

B = Sensor B only

A&B = Sensors A and B displayed at the same time

OFF = Turns the peak meter display off.

The peak meter display range covers 12 dB. When above the displayed

maximum or below the displayed minimum, the range is switched by 10 dB

in the appropriate direction.

Note that in the event that the channel is displaying an alternative mea

surement (e.g., external volts from the rear panel BNC) the peak meter

continues to represent the Sensor A and/or B data. This is very useful for

monitoring an external voltage on the meter, while peaking up a response

being monitored by a sensor (e.g., RF output).

Query:

DPEAK?

Returned

String:

DPEAK <mode>

DTRGD Display Trigger Delay

PROFILE SETUP

Syntax:

DTRGD <val>

val:

0.0 to 7.0 seconds

Remarks:

The delay time from the trigger point to when the profile starts to be drawn

(refer to Figure 4-4, page 4-20).

Example:

DTRGD 1.25MS Sets the display trigger delay to 1.25 ms.

Query:

DTRGD?

Returned

String:

DTRGD <val>

DUTY Duty cycle

SENSOR

Syntax:

DUTY <s>,<duty_cycle>

A or B

duty cycle:

0.1 to 100%

Remarks:

Applies a duty cycle to the selected sensor. An offset will be applied based

on the entered value.

Example:

DUTY A,50

Specifies a duty cycle of 50% that will alter the displayed readings by ap

proximately +3.01 dB.

6-34 ML2430A OM

ML24XXA NATIVE COMMANDS GPIB OPERATION

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 270 271

Comentários a estes Manuais

Sem comentários

Anritsu ML2430A Manual do Utilizador Página 121

Comentários a estes Manuais

Manuais e produtos relacionados com Medição, teste e controlo Anritsu ML2430A