Anritsu MP1777A Especificações Página 52

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 66
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 51
DIGITAL LINK MEASURING INSTRUMENTS
180 For product ordering information, see pages 4 10
POS Module
Model MU120103A MU120104A MU120105A MU120106A
OC-48/STM-16 OC-48/STM-16 OC-192/STM-64 OC-192/STM-64
Wavelength: 1260 to 1360 nm Wavelength: 1500 to 1580 nm Wavelength: 1290 to 1330 nm Wavelength: 1530 to 1565 nm
Number of port: 1 Number of port: 1 Number of port: 1 Number of port: 1
Ports
Connector: SC Connector: SC Connector: SC Connector: SC
Bit rate: 2488.320 Mbit/s (NRZ) Bit rate: 2488.320 Mbit/s (NRZ) Bit rate: 9953.280 Mbit/s (NRZ) Bit rate: 9953.280 Mbit/s (NRZ)
Output level: 5 to 0 dBm Output level: 1.0 to +2.0 dBm Output level: 6 to 0 dBm Output level: 1.0 to +2.0 dBm
Input sensitivity: 18 to 0 dBm Input sensitivity: 28 to 9 dBm Input sensitivity: Input sensitivity:
11 to 1.0 dBm 14 to 3.0 dBm
LEDs Link, Tx, Rx/error, optical send
Clocks Internal (MU120103A/120104A : ±50 ppm variable, MU120105A/120106A : ±100 ppm), receive signal, lock (64 kHz + 8 kHz,
1.5 MHz, 2 MHz, 1.5 Mbit/s, 2 Mbit/s)
Frame: SDH/SONET
Alarm addition: LOS, LOF, MS-AIS, MS-RDI, MS-TIM, AU-AIS, AU-LOP, HP-SLM, HP-TIM, HP-RDI, HP-UNEQ
Timing: Single, single burst frame, alternative [alarm frame (0 to 8000), Normal frame (0 to 8000)], all
Error insertion: FAS, bits all, B1, B2, B3, MS-REI, HP-REI
SDH/SONET settings Timing:
Single, single burst bit (1 to 64000), rate (1E-3, 1E-4, 1E-5, 1E-6, 1E-7, 1E-8, 1E-9),
programmed rate [AE-B
A: 1.0 to 9.9 (0.1 steps), B: 3 to 10]
APS (K1/K2)
Sequence generation: 2 to 64 words, repeat (8000 frames)
Mapping
PPP scramble: On/off
PPP FCS: CRC32
MPLS label: Up to 10 MPLS labels can be appended. Fixed setting
Frame settings
Protocol editing: IPv4, IPv6, TCP, UDP, IGMP, ICMPv4, RIP, DHCP
Data field:
Can set any 4 parts in data field.
All 1s, all 0s, alternate 1/0 (each bit, each 2 bits, each nibble, each byte, each 2 bytes), increment, decrement, random, user
programmable, single PRBS9, time stamp, sequence number, test frame
Frame length 8 bytes to 64 kbytes (settable as auto, fixed, increment, or random)
Stream transport mode:
Continuous, continuous burst, stop after this stream, next stream, jump to stream.
Jump to stream for count (loop count: 1 to 16000000, frame count per burst: 1 to 16000000, burst count per stream: 1 to 16000000)
Inter frame gap: Inter frame gap:
Stream settings 3.2 ns to 120 s, resolution at 3.2 ns, settable as fixed, random 0.8 ns to 120 s, resolution at 0.8 ns, settable as fixed, random
Inter burst gap: Inter burst gap:
3.2 ns to 120 s, resolution at 3.2 ns, settable as fixed 0.8 ns to 120 s, resolution at 0.8 ns, settable as fixed
Inter stream gap: Inter stream gap:
3.2 ns to 120 s, resolution at 3.2 ns, settable as fixed 0.8 ns to 120 s, resolution at 0.8 ns, settable as fixed
Number of streams 256 streams/port
Error insertion FCS error, abort frame, fragment, undersize, IP header checksum error, TCP/UDP header checksum error
SONET/SDH:
B1, B2, B3, HP-IEC, MS-REI, HP-REI, LOS, LOF, OOF, MS-AIS, MS-RDI, AU-AIS, AU-LOP, HP-SLM, HP-TIM, HP-RDI,
HP-UNEQ
Counter
Justification: NDF, +PJC, PJC
PPP/IP/TCP/UDP:
Transmitted frame, received frame, transmitted bytes, received bytes, received bytes before stuffing, transmitted bytes after stuffing,
fragment, undersize, oversize, FCS error, abort error, capture trigger, capture filter, transmitted ping reply, transmitted ping request,
received ping reply, received ping request, QoS 0 to 7, user defined 1, user defined 2, transmitted IP, received IP, IP checksum
error, TCP checksum error, UDP checksum error
Latency Maximum, minimum, average
Alarm arrival time
Time resolution: 1 µs, 10 µs, 100 µs, 1 ms, 10 ms, 100 ms, 1 s
variation measurement
QoS counter settings Using least 3 bits of RFC2474 DSCP field, 8-stage priority packet count
Capture buffer 64 Mbytes 256 Mbytes
Capture filter
At following conditions for each port, capture filter condition settings:
Destination IP address, source IP address, 32-bit pattern (settable bit length and offset) x 2, error conditions
At following conditions for each port, capture trigger condition settings:
Capture trigger Destination IP address, source IP address, 32-bit pattern (settable bit length and offset) x 2, error conditions, traffic over, latency
over, external trigger input
Protocol decode PPP, LCP, IPCP, MPLS, IPv4, ICMPv4, IPv6, TCP, UDP, IGMP, RIP, BGP4, DHCP
Protocol emulate PING, IGMP, BGP4
PPP
STM-16C VC4
16C CiscoHDLC
Bulk
PPP
STM-64C VC4
64C CiscoHDLC
Bulk
Vista de página 51
1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 65 66

Comentários a estes Manuais

Sem comentários